Making "T" Type Transitions |
1.) Rob Johnson National Training Manager for Basic Coatings |
2.) The blade is raised until the bottom of the carbide tip is level with the top of the board |
3.) The tongue of the board is cut off |
4.) Rob draws out the transition |
|
5.) First cut |
6.) Second cut |
7.) T transition taking shape |
8.) Adjusting blade height with saw turned off |
|
9.) Cutting off waste to leave just T area |
10.) T transition takes shape |
11.) Taper ends |
12.) Completed but the center of the T will need to be supported. Place a small shim under the center when installed. |
|